Connecting The Finisher D707 - Ricoh MP C6502SP Field Service Manual

Hide thumbs Also See for MP C6502SP:

Table of Contents

2. Installation

3. Attach the coupling seal [A] to the copier.

4. Dock the finisher. (See "Connecting the Finisher D707")

Connecting the Finisher D707

1. Open the front door of the finisher.

2. Pull out the locking lever [A]. ( x 1)

3. Align the finisher [B] with the joint brackets [C], then slowly push the finisher onto the brackets.

4. Connect the finisher cable [D] to the copier

5. Push in the locking lever. [A]

6. Check that the top edges of the finisher are parallel with edges of the device (or copier) to the right.

7. Fasten the locking lever [A]. ( x 1)

8. Close the front door.

Table of Contents