Table of Contents
Advertisement
[Note]
The following diagram describes the firmware update procedure, as well as checking the availability of the latest
firmware.
Random period
（0~60 minutes)
Random period
(Random period of 3.5-
10.5 days, but may
change)
INFO lamp is
INFO lamp is
blinking orange
POWER lamp is orange
(INFO lamp OFF)
Firmware update takes about five minutes.
The update sequence is as follows.
1) Download the firmware file from the server.
2) The POWER lamp flashes orange and the firmware starts to write to memory.
It takes about two minutes to complete.
3) All lamps become green and then the device restarts.
4) It takes about two minutes for the device to start up.
5) Confirm that the INFO lamp is turned off after the device has started up.
Product
Power supply ON
IP setup
Information notification
Information notification
☞
New firmware available
☞
Press OPT2 switch
Acquiring firmware
☞
Firmware writing
Device restart
☞
Server
Startup check
Regular check
At least 2 seconds
Check when device starts
After a random period, it
checks if there is a new
firmware from the
acquired IP address.
Regular check
It checks if there is a
new firmware after every
random period.
New firmware is available
INFO lamp lights up
orange when new
firmware is available.
Firmware update
Firmware is updated
when the OPT2 switch is
pressed at least 2
seconds.
|Function Specification
79
Advertisement
Table of Contents
