Time Setting - NEC ZA-SA3500G Function Manual

5.6.11. Time Setting

The time of this product is acquired from the NTP server.
Refer to this section when an NTP server is specified.

One NTP server information can be set.
When this product restarts, time information is not saved (time information is reset).

[Change NTP server]
1. Open [TOP]-[Maintenance]-[Maintenance]-[Time].
2. Select "Specify NTP Server Name" for Automatic Time Setup Function.
3. Input the address of the NTP server.
4. Click the "Apply" button.
5. Click the "Save" button to save the setting.
[Change time zone]
1. Open [TOP]-[Maintenance]-[Maintenance]-[Time].
2. Select "Specify NTP Server Name" for Automatic Time Setup Function.
3. Change the time zone.
4. Click the "Apply" button.
5. Click the "Save" button to save the setting.
[When the NTP server is not used]
1. Open [TOP]-[Maintenance]-[Maintenance]-[Time].
2. Select "Disable" for Automatic Time Setup Function.
3. Input the current time.
4. Click the "Apply" button.
5. Click the "Save" button to save the setting.
[Note]
The time of this product returns to its initial value (2015/11/14 00:00:00 JST) after restarting. If the NTP server is not
used, and if the device time is set in the Web setting, set the time every time the product is restarted.
160 Setting/Setting Confirmation|