Switch Operation; Factory Default - NEC ZA-SA3500G Function Manual

5.10. Switch Operation

This product has four (4) switches. Refer to the diagram of Section 2.3.1 for the location of each switch.
Display Function
RESET For initialization
OPT1 Switch for security/scan function
・Activation
・Threat detection state cancellation
OPT2 For firmware update
WPS WPS switch

5.10.1. Factory Default

Configuring to factory default will erase the contents set in this product.
1. Confirm that the POWER lamp of unit is lit in green.
Wait for about 140 seconds when turning back the power on.
2. The RESET switch is at the back of this product. Press the switch using a thin stick or wire (material that does not
conduct electricity like toothpick tip) until POWER, NETWORK, and WIRELESS lamps begin to flash green, then let
go. It takes about 6 to 10 seconds for POWER, NETWORK, and WIRELESS lamps to flash green on and off.
This completes the initialization.
After initialization, this product will restart automatically.
After each lamp lits all green, wait until all except for the POWER lamp turn off.
(The status of other lamps will change depending on usage situation.)
[Note]
Setting values can also be initialized on Web setting.
The initialization range is the same for both the Web setting and the RESET switch.
After restarting this product, there is no need to perform an activation operation.
Switch Location
Back right side
Front right side
Back left side
Front left side
|Setting/Setting Confirmation
Remarks
Push type
Push type
Push type
Push type
295