Automatic Setting Of Wi-Fi By Wps Switch - NEC ZA-SA3500G Function Manual

5.10.5. Automatic Setting of Wi-Fi by WPS Switch

The WPS switch of this product can be used to automatically configure Wi-Fi and wireless LAN terminals compatible
with WPS-PBC.
Setting procedure
*During setup, place this product and WLAN terminal near each other. (Approximately 1 meter)
[Caution]
The WPS function is disabled in the following cases:
● Wireless LAN function is disabled
● Wireless MAC address filtering function is enabled
● Wireless encryption mode of the primary SSID is set to TKIP or 802.1X (EAP)
● ESS-ID stealth function of the primary SSID is enabled
1. Activate the WPS-PBC function of the wireless LAN terminal
*For the start up, refer to the instruction manual attached to the wireless LAN terminal.
2. Continue to hold down the WPS switch on the front of this product and release the WIRELESS lamp of this product
as it flashes orange.
3. Confirm that the WIRELESS lamp of this product lights orange.
*After the WPS processing is over, the WIRELESS lamp will light green.
If it fails, the WIRELESS lamp blinks red for about 10 seconds.
If restarting from step 1 fails again, refer to the instruction manual of the wireless LAN terminal and manually set it
using the SSID and encryption key of this product.
*Check the SSID and encryption key on the device label on the base of this product or on the Web setting.
|Setting/Setting Confirmation 297