Table of Contents
Advertisement
[Behavior of operation and notification when threat is detected]
Block setting
Operation during detection
Access to concerned website is
blocked.
*1: It notifies similarly as the Antivirus function during detection.
Therefore, check the security log to see which either function detection.
*2: HTTPS block display is different depending on the browser. In case of the sample display, the browser is Internet
Explorer 11.
*3: It must be set from Web setting.
Log only setting
Operation during detection
Log output only
[How to stop the security function]
When a normal website is erroneously detected as a threat, stop the function temporarily using the following method.
Stopping the operation of the security function increases security risk. Therefore, stop the function after confirming
your risks and responsibility.
How to stop
Remove the check on "Enable Web Guard" from "Web
Guard setting". (Refer to Section 5.8.6)
54
Function
Specification|
How to notify during detection
・ALERT1 lamp *1
blinking orange (60 seconds)
->Orange lights up
・It will be displayed in the browser
that it has been blocked.
(Sample display of blocked HTTP)
(Sample display of blocked HTTPS) *2
・Log is displayed in the security log.
(It is necessary to view it in Web
setting.)
・Mail Notification *3
・Lamp display of PATLITE device *3
How to notify during detection
Log in the security log
(It is necessary to view it in Web
setting.)
Remarks
How to cancel detection state
・Orange ALERT1 lamp light is
cancelled by any of the following
methods.
・Press OPT1 switch for a few
seconds
・View the security log on the Web
setting
・Cancel blocked browser display
by closing the browser.
How to cancel detection state
－
Advertisement
Table of Contents
