Usb Device Function - NEC ZA-SA3500G Function Manual

3.8. USB Device Function

The contents of this section are common specifications in bridge mode and router mode.
By connecting a USB device to the USB port, settings values can be stored on the device periodically, save the settings
on the Web setting, and restore the settings.
Please refer to sections 3.8.1 and 3.8.2 for the procedure.
The USB device to be connected must satisfy the following conditions:
[USB Device Requirements]
Compatible with USB mass storage class (hereinafter, supported USB device is described as USB storage)

Formatted with FAT32

Has only one partition

Volume size does not exceed 2TB

Has no encryption function

20 MB of free space

[Note]
OPT2 lamp flashes orange when USB storage is mounted on USB port.

*If OPT2 lamp does not flash orange, please confirm [USB Device Requirements].
If the setting values are saved or restored succesfully, OPT2 lamp flashes green.

*If OPT2 lamp does not flash green, please confirm [USB Device Requirements].
If other OPT2 lamp indications appear, please refer to section 2.3.3.

USB hub is not supported.

[Caution]
Take note that connecting a non-standard USB device can cause damage to this product.

Take note of the following when connecting a USB storage.

・Be sure to hold the main body of this product.
・Do not touch the connector by hand.
・Be careful of the connector orientation and do not force it.
|Function Specification 115