Table of Contents
Advertisement
DPD-Keepalive
Interval (sec)
DPD-Keepalive Retry
Count
IKE Retry Interval
(sec)
IKE Retry Count
IKE Phase 2 Settings
Remote Peer Setting
Remote Peer
Local ID:1~5
Remote ID:1~5
212
Setting/Setting
communication disconnection of the
IPsec tunnel.
• Checked: when DPD-Keepalive
function is used.
• Unchecked: when DPD-Keepalive
function is not used.
Set the transmission interval of the
DPD-Keepalive function in seconds to
detect communication disconnection of
the IPsec tunnel.
Set the number of retries of the DPD
Keepalive function for detecting
communication disconnection of the
IPsec tunnel.
Specify the retransmission interval
(seconds) to be performed when a key
exchange packet does not reach the
peer. It can be set from 5-60 seconds.
Specify the number of retransmissions
to be performed when the key exchange
packet does not reach the peer. It can
be set from 2-10 times.
Set the specification method of the
IPsec peer device.
• Any: Select when the IP address of
the IPsec peer device is not fixed.
• IP address: Select when the IP
address of the IPsec peer device is
fixed.
Set the IP address when "IP address" is
selected in "Remote Peer Setting".
Set the ID payload (IP address and
subnet mask) of the device to transmit
in IKE phase 2.
Set the ID payload (IP address and
subnet mask) of the device to receive in
IKE phase 2.
Confirmation|
When this function is
enabled, the DPD packet
is sent every 30 seconds.
Set it according to the ID
of the peer for IPsec
communication. If there
are multiple subnets
subject to IPsec, input
more than one in the local
ID.
Set it according to the ID
of the peer for IPsec
communication. If there
Not set
Not set
Not specified
Not specified
Any
Not set
Not Set
Not Set
Advertisement
Table of Contents
