Factory Default Settings - NETGEAR Insight Instant AirBridge User Manual

Factory default settings

You can reset the AirBridge to the factory default settings, which are shown in the
following table. However, many settings depend on the operation mode that you
configure on the Day Zero Easy Setup configuration page (see Operation mode and
default settings after the Day Zero Easy Setup configuration on page 30).
For information about resetting the AirBridge to its factory settings, see Reset the
AirBridge to factory default settings on page 104.
Table 12. AirBridge factory default settings
Feature
Access
Default IP address
DHCP client
Local login user name
Local login password
HTTPS
HTTP forwarded to HTTPS
SSH access
Operation modes and operation mode-dependent features
Operation mode
AirBridge mode
Channel HT mode
Master time slot
Satellite priority
Factory Default Settings and
Technical Specifications
Insight Instant AirBridge WBC502 User Manual
Default Setting
192.168.0.100
Enabled
admin (case-sensitive, nonconfigurable)
password (case-sensitive, configurable)
The first time that you log in to the local browser UI, you must define a new local
login password.
Enabled
Enabled
Disabled
No default operation mode. You must select one of the following operation mode
that first time that you log in to the local browser UI:
AirBridge Master
AirBridge Satellite
Access Point
Client Bridge
Enabled when the operation mode is AirBridge Master or AirBridge Satellite
Not applicable when the operation mode is Access Point or Client Bridge
40 MHz when the operation mode is AirBridge Master or Access Point
Not applicable when the operation mode is AirBridge Satellite or Client Bridge
Auto when the operation mode is AirBridge Master
Not applicable in any other operation mode
High when the operation mode is AirBridge Satellite
Not applicable in any other operation mode
145 User Manual