Manage Access Security Settings; Change The Local Login Password - NETGEAR Insight Instant AirBridge User Manual

i. From the Security Mode menu, select one of the following options, depending
on the security that the SMPT server uses:
• None. The SMPT server does not use security. This is the default setting.
• SSL/TLS. The SMPT server uses the SSL or TLS security protocol
• STARTLS. The SMPT server uses the STARTLS security protocol.
6. To send a test email, click the Send Test Mail button.
7. Verify that the recipient receives the email.
8. Click the Apply button.
Your settings are saved and applied immediately.

Manage access security settings

You can change the local device password for access to the local browser UI of the
AirBridge. You can also manage the SSH and HTTPS settings.

Change the local login password

The local login password is the password that lets you log in to the local browser UI.
When you performed the initial configuration on the Day Zero Easy Setup page, you
were required to change the local login password. You can change it again.
The password must be 8 to 63 characters in length and must contain at least one
uppercase letter, one lowercase letter, and one number. The following special characters
are allowed:
! @ # $ % ^ & * ( )
To change the local login password:
1. Open a web browser from a computer that is connected to the same network as the
AirBridge or directly to the AirBridge through an Ethernet cable or WiFi connection.
2. Enter the IP address that is assigned to the AirBridge.
The login page displays.
If your browser does not display the login page but displays a security message and
does not let you proceed, see Log in to the AirBridge after initial setup on page 31.
3. Enter the AirBridge user name and local device password.
The user name is admin. The local device password is the one that you specified
the first time that you logged in. The user name and password are case-sensitive.
Maintain the AirBridge
Insight Instant AirBridge WBC502 User Manual
114 User Manual