Table of Contents
Advertisement
behavior. When you connect a powered-on network device such as a switch to the
LAN port on the power adapter, the LAN1 LED on the AirBridge lights amber.
• LAN2 LED. When a powered-on device such as a PTZ camera is directly connected
to the LAN2 port on theAirBridge, the LAN2 LED on the AirBridge lights amber.
If the LAN1 LED or LAN2 LED remains off while a powered-on device is connected as
described above, a hardware connection problem might be occurring. Check these
items:
• Make sure that the Ethernet cable connectors are securely plugged in at the
AirBridge, the power adapter, and the network device.
• Make sure that the connected network device is actually turned on.
• Make sure that you are using the correct Ethernet cable. Use a standard Category
5 Ethernet patch cable. If the network device incorporates Auto Uplink™ (MDI/MDIX)
ports, you can use either a crossover cable or a normal patch cable.
Troubleshoot the WiFi connectivity between
a satellite and a master or a client bridge and
an access point
Tip: If you want to change the WiFi settings of the AirBridge's network, use a wired
connection to avoid being disconnected when the new WiFi settings take effect.
If you cannot connect a satellite to an AirBridge that functions as a master or a client
bridge to an AirBridge that functions as an access point, check these items:
• On the satellite or client bridge, make sure that the right signal strength indicator
(SSI) LED is solid green or the middle SSI LED is solid amber.
For more information about hardware setup troubleshooting and about the SSI LEDs,
which indicate the strength of the signal for the WiFi connection either between the
satellite and the master or between the client bridge and the access point, see the
hardware installation guide, which you can download by visiting
netgear.com/support/download/.
Perform Diagnostics and
Troubleshooting
Insight Instant AirBridge WBC502 User Manual
138
User Manual
Advertisement
Table of Contents
Troubleshooting
