Operation Mode And Default Settings After The Day Zero Easy Setup Configuration - NETGEAR Insight Instant AirBridge User Manual

15. After you complete the setup process, or both the setup process and your
configurations, you can change the computer back to its original IP address settings.
Operation mode and default settings after
the Day Zero Easy Setup configuration
After you complete the Day Zero Easy Setup configuration and specify the AirBridge to
function in one of four operation modes, the default settings are as stated in the following
table.
Note: In some countries and regions, the default settings might differ from the settings
that are stated in the following table.
Table 2. Operation mode default settings after the Day Zero Easy Setup configuration
Default Setting AirBridge Master
AirBridge mode Enabled
Auto RF Enabled
Channel HT mode 40 MHz
Client Limit N/A
Distance 1 km (0.6 miles)
Master Time Slot Auto
Satellite Priority N/A
Note: For information about manually configuring the operation mode, see Manually
Configure or Change the Operation Mode on page 34.
Access the AirBridge and Use
the Easy Setup Method
Insight Instant AirBridge WBC502 User Manual
AirBridge Satellite
Enabled
Enabled
N/A
N/A
1 km (0.6 miles)
N/A
High
Access Point
N/A
Enabled
40 MHz
32
1 km (0.6 miles)
N/A
N/A
30
Client Bridge
N/A
Enabled
N/A
N/A
1 km (0.6 miles)
N/A
N/A
User Manual