NETGEAR Insight Instant AirBridge User Manual page 50

3. Enter the AirBridge user name and local device password.
The user name is admin. The local device password is the one that you specified
the first time that you logged in. The user name and password are case-sensitive.
If you previously managed the AirBridge through the NETGEAR Insight app or Insight
Cloud portal, enter the Insight network password for the Insight network location to
which the AirBridge was assigned (see Connect over WiFi using the NETGEAR Insight
App on an iOS or Android mobile device on page 13).
The Device Status page displays the Device Information section and other sections.
4. Under Network, select Basic.
The page that displays shows the IPv4 Settings, IPv6 Settings, and Spanning Tree
Protocol (STP) Settings sections.
5. In the Spanning Tree Protocol (STP) Settings section, specify the settings that are
described in the following table:
Setting
Status
Hello Time
Max Age
Forward Delay
Priority
6. Click the Save button.
Your settings are saved to be applied later.
Manage the Wired Network
Settings
Insight Instant AirBridge WBC502 User Manual
Description
Select one of the following radio buttons:
• Enable. STP is enabled. This is the default setting.
• Disable. STP is disabled.
The interval in seconds between handshake packets that the AirBridge sends to
communicate information about the topology throughout the entire bridged LAN.
The range is 1–10 seconds. The default is 2 seconds.
The period in seconds within which the AirBridge must receive a hello packet from
another device in the spanning tree before the AirBridge assumes that the device is
inactive.
The range is 6–40 seconds. The default is 20 seconds.
The period in seconds that a device spends in each of the listening and learning
states before entering the forwarding state. This delay is provided so that when a
new device enter a busy network, the device analyzes data traffic before participating
in the network.
The range is 4–30 seconds. The default is 15 seconds.
The priority of the AirBridge in the spanning tree. A smaller number means a higher
priority.
The range is 0–65535. The default is 32768.
50 User Manual