NETGEAR Insight Instant AirBridge User Manual page 105

After you reset the AirBridge to factory default settings, the user name is admin, the
local login password is password, the LAN IP address is 192.168.0.100, the AirBridge's
DHCP client is enabled, the default management SSID is shown in the format
NETGEARxxxxxx-SETUP, and the default password for WiFi access is sharedsecret. For
a list of factory default settings, see Factory default settings on page 145.
To reset the AirBridge to factory default settings using the local browser UI:
1. Open a web browser from a computer that is connected to the same network as the
AirBridge or directly to the AirBridge through an Ethernet cable or WiFi connection.
2. Enter the IP address that is assigned to the AirBridge.
The login page displays.
If your browser does not display the login page but displays a security message and
does not let you proceed, see Log in to the AirBridge after initial setup on page 31.
3. Enter the AirBridge user name and local device password.
The user name is admin. The local device password is the one that you specified
the first time that you logged in. The user name and password are case-sensitive.
If you previously managed the AirBridge through the NETGEAR Insight app or Insight
Cloud portal, enter the Insight network password for the Insight network location to
which the AirBridge was assigned (see Connect over WiFi using the NETGEAR Insight
App on an iOS or Android mobile device on page 13).
The Device Status page displays the Device Information section and other sections.
4. Under System Manager, select Firmware.
The page displays the Firmware Upgrade section and the Backup/Restore Settings
section.
5. In the Backup/Restore Settings section, click the Reset to Default Reset button.
The page displays the reset progress.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reset.
For example, do not close the browser, click a link, or load a new page. Do not turn
off the AirBridge. Wait until the AirBridge finishes.
When the reset is finished, your address bar of your web browser might show
192.168.0.100, which is the default IP address of the AirBridge.
6. In the address bar, enter the IP address that was assigned to the AirBridge before
you reset the AirBridge to factory default settings.
The Day Zero Easy Setup page displays.
If you do not know the IP address, see Access the AirBridge for initial configuration
on page 12.
Maintain the AirBridge
Insight Instant AirBridge WBC502 User Manual
105 User Manual