Set Up Wpa2-Enterprise Security On A Master Or Access Point.69 - NETGEAR Insight Instant AirBridge User Manual

Set up WPA2-Enterprise security on a master or access point
Use this task if the selection from the Operation Mode menu is AirBridge Master or
Access Point.
When you set up WPA2-Enterprise security on a master or access point, you must specify
the RADIUS server authentication settings. As an option, you can also specify an
accounting RADIUS server.
The link partner or partners of the master or access point must use the same RADIUS
server authentication settings.
To set up WPA2-Enterprise security on a master or access point:
1. Open a web browser from a computer that is connected to the same network as the
AirBridge or directly to the AirBridge through an Ethernet cable or WiFi connection.
2. Enter the IP address that is assigned to the AirBridge.
The login page displays.
If your browser does not display the login page but displays a security message and
does not let you proceed, see Log in to the AirBridge after initial setup on page 31.
3. Enter the AirBridge user name and local device password.
The user name is admin. The local device password is the one that you specified
the first time that you logged in. The user name and password are case-sensitive.
If you previously managed the AirBridge through the NETGEAR Insight app or Insight
Cloud portal, enter the Insight network password for the Insight network location to
which the AirBridge was assigned (see Connect over WiFi using the NETGEAR Insight
App on an iOS or Android mobile device on page 13).
The Device Status page displays the Device Information section and other sections.
4. Under Network, select Wireless.
The Wireless Settings page displays.
5. In either the Wireless Settings - 5G section or the Wireless Settings - Access Point
section (the name of the section depends on whether the AirBridge mode is enabled),
do one of the following:
• To configure WPA2-Enterprise security for the default 5 GHz SSID or another
previously enabled 5 GHz SSID, click the Edit button for the 5 GHz SSID.
• To enable and configure WPA2-Enterprise security for a new 5 GHz SSID, select
the Enabled check box for a disabled 5 GHz SSID, and then click the Edit button
for the 5 GHz SSID.
A new page opens.
Manage the WiFi and Radio
Features
Insight Instant AirBridge WBC502 User Manual
69 User Manual