Mic Leds; Mx104 Power Overview; Table 6: Sfp+ Port Leds - Juniper MX104 Hardware Manual

MX104 3D Universal Edge Router Hardware Guide

MIC LEDs

Related
Documentation

MX104 Power Overview

18
10GBASE-LR (model numbers EX-SFP-10GE-LR and SFPP-10GE-LR)
10GBASE-LRM (model number SFPP-10GE-LRM)
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications.
Each front-pluggable MIC has LEDs located on the faceplate. For more information about
LEDs on the MIC faceplate, see the "LEDs" section for each MIC in the
.
Module Reference
The built-in 10-Gigabit Ethernet MIC labeled
transceiver has one pair of port LEDs.
detail.

Table 6: SFP+ Port LEDs

Name Location
Activity Left
Link Right
MX104 Port and Interface Numbering on page 5
Replacing an MX104 MIC on page 93
Maintaining the MX104 MICs and Network Ports on page 73
The MX104 router uses either AC or DC power supplies (see
Figure 10 on page 20). The power supplies are located in the front of the chassis and offer
1+1 redundancy. Each power supply has a handle, an ejection tab, and a status LED.
CAUTION: The router cannot be powered from AC and DC power supplies
simultaneously.
When two power supplies are present, they share power almost equally within a fully
populated system. If one power supply in a redundant configuration fails or is removed,
the remaining power supply assumes the entire electrical load without interruption. A
single power supply provides the maximum configuration with full power for as long as
the router is operational. A second power supply can be installed for redundancy. Each
power supply is cooled by its own internal cooling system.
XE accepts 10-Gigabit Ethernet SFP+. Each
Table 6 on page 18
Color State
Green Blinking
– Off
Yellow On
– Off
MX Series Interface
describes the LEDs in more
Description
The port is receiving data.
The port is not receiving data.
Link is online.
No link.
Figure 9 on page 19
Copyright © 2014, Juniper Networks, Inc.
and