Figure 44: Removing Transceivers - Juniper MX104 Hardware Manual

MX104 3D Universal Edge Router Hardware Guide
110
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Remove the cable connector from the transceiver.
4.
Pull the ejector handle out from the transceiver to unlock the transceiver.
5.
CAUTION: Make sure that you open the ejector handle completely until
you hear it click. This action prevents damage to the transceiver.
Use needlenose pliers to pull the ejector handle out from the transceiver.
Grasp the transceiver ejector handle, and pull the transceiver approximately 0.5 in. (1.3
6.
cm) out of the router.
Using your fingers, grasp the body of the transceiver, and pull it the rest of the way
7.
out of the router.

Figure 44: Removing Transceivers

Place a rubber safety cap over the transceiver.
8.
Place the removed transceiver on an antistatic mat or in an electrostatic bag.
9.
CAUTION: After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.
Copyright © 2014, Juniper Networks, Inc.