Built-In 10-Gigabit Ethernet Mic - Juniper MX104 Hardware Manual

Built-in 10-Gigabit Ethernet MIC

Copyright © 2014, Juniper Networks, Inc.
complete specifications, see MICs Supported by MX Series Routers in the
.
Module Reference
The built-in 10-Gigabit Ethernet MIC is fixed on the MX104 router. The MIC is labeled
and is located on the front panel. The built-in 10-Gigabit Ethernet MIC has the following
components:
Hardware features:
Four 10-Gigabit Ethernet ports labeled
High-performance throughput on each port at speeds up to 10 Gbps
Line-rate on all four 10-Gigabit Ethernet ports
LAN-PHY mode at 10.3125 Gbps
WAN-PHY mode at 9.953 Gbps
Maximum transmission units (MTUs) of up to 9192 bytes
One green Link LED per port
Software features:
Configurable LAN-PHY and WAN-PHY mode options
Synchronous Ethernet support
Optical diagnostics and related alarms
Virtual Router Redundancy Protocol (VRRP) support
IEEE 802.1Q virtual LANs (VLANs) support
Remote monitoring (RMON) EtherStats
Source MAC learning
MAC accounting and policing—Dynamic local address learning of source MAC addresses
Flexible Ethernet encapsulation
Multiple Tag Protocol Identifiers (TPID)
Cables and connectors:
Duplex LC/PC connector (Rx and Tx)
Fiber-optic 10-gigabit small form-factor pluggable (SFP+) transceivers:
Connector: Duplex LC/PC (Rx and Tx)
10GBASE-SR (model numbers EX-SFP-10GE-SR, EX-SFP-10GE-USR, and
SFPP-10GE-SR)
10GBASE-ER (model numbers EX-SFP-10GE-ER and SFPP-10GE-ER)
Chapter 2: MX104 Hardware Components
through , left to right
2/0/0 2/0/3
MX Series Interface
XE
17