Agency Approvals And Compliance Statements; Agency Approvals For Mx104 Routers - Juniper MX104 Hardware Manual

Related
Documentation

Agency Approvals and Compliance Statements

Agency Approvals for MX104 Routers

Copyright © 2014, Juniper Networks, Inc.
Appendix A: Safety and Regulatory Compliance Information for the MX104 Router
Strong sources of electromagnetic interference (EMI) can destroy the signal drivers and
receivers in the router and conduct power surges over the lines into the equipment,
resulting in an electrical hazard. It is particularly important to provide a properly grounded
and shielded environment and to use electrical surge-suppression devices.
WARNING: The intrabuilding port(s) of the equipment or subassembly is
suitable for connection to intrabuilding or unexposed wiring or cabling only.
The intrabuilding port(s) of the equipment or subassembly MUST NOT be
metallically connected to interfaces that connect to the OSP or its wiring.
These interfaces are designed for use as intrabuilding interfaces only (Type
2 or Type 4 ports as described in GR-1089-CORE, Issue 4) and require isolation
from the exposed OSP cabling. The addition of primary protectors is not
sufficient protection to connect these interfaces metallically to OSP wiring.
General Safety Guidelines for Juniper Networks Devices on page 117
General Safety Warnings for Juniper Networks Devices on page 118
Agency Approvals for MX104 Routers on page 147
Compliance Statements for NEBS for MX104 Routers on page 149
Compliance Statements for EMC Requirements for MX104 Routers on page 149
Compliance Statements for Environmental Requirements for Juniper Networks
Devices on page 151
Compliance Statements for Acoustic Noise for MX104 Routers on page 151
The MX104 router complies with the following standards:
Safety:
CAN/CSA-22.2 No. 60950-1 (2007), Safety of Information Technology Equipment
UL 60950-1 Information Technology Equipment—Safety - Part 1: General
Requirements
EN 60950-1 European Norm, Safety of Information Technology Equipment
147