Mx104 Routing Engine Auxiliary And Console Ports Specifications; Cable Specifications; Pinouts; Mx104 Cable Connector Specifications - Juniper MX104 Hardware Manual

MX104 Routing Engine Auxiliary and Console Ports Specifications

Cable Specifications

Pinouts

Copyright © 2014, Juniper Networks, Inc.
The Routing Engine contains two ports labeled
NOTE: The AUX port is not supported.
The ports are asynchronous serial interfaces that accept an RJ-45 connector. The ports
connect the Routing Engine to an auxiliary or console management device.
Table 43 on page 179 describes the RJ-45 connector pinout.
Cable Specifications on page 179
Pinouts on page 179
Table 42 on page 179 lists the specifications for the cables that connect to console port.

Table 42: MX104 Routing Engine Console Port Cable Specifications

Specification
Cable specification
Cable/wire supplied
Maximum length
Router receptacle
Table 43 on page 179 describes the RJ-45 connector pinout.

Table 43: Console Port Pinouts

Pin Signal
1 RTS
2 DTR
3 TXD
4 Ground
5 Ground
6 RXD
Appendix F: MX104 Cable Connector Specifications
and .
AUX CONSOLE
Value
RS-232 (EIA-232) serial cable
One 6-ft (1.83-m) length with RJ-45/DB-9
connectors
6 ft (1.83 m)
RJ-45 female
Description
Request to Send
Data Terminal Ready
Transmit Data
Signal Ground
Signal Ground
Receive Data
179