MX104 3D Universal Edge Router Hardware Guide
6
Figure 3: MX104 Interface Port Mapping Example
MPC 0 and MPC 1 have two slots each that accept MICs. The MICs are represented as
and
in the CLI and are logically divided into PICs depending on their type. A
MIC 0
MIC 1
MIC installed in the left-most MIC slot (
PIC 1
. A MIC installed in the right-most MIC slot (
.
PIC 3
MPC 2 houses a 4-port 10-Gigabit Ethernet MIC. Both the MPC and the MIC are considered
fixed and are built into the front panel of the chassis. The MPC is represented as
in the CLI. The MIC is represented as
PIC, which is represented as
The port numbers on the MICs correspond to the port numbers on the interface. See the
MX Series Interface Module Reference
Table 4 on page 7
summarizes the relationship between the components and the
interface names.
0
1
2
3
0
1
2
3
or
) is represented in the CLI as
0/0
1/0
0/1
in the CLI and is logically divided into a single
MIC 0
.
PIC 0
for more information about specific MICs.
PIC 0
or
1/1
) is represented as
PIC 2
Copyright © 2014, Juniper Networks, Inc.
and
and
FPC 2