1-Port Clear Channel Ds3/E3 Gpim Components - Juniper SRX Series Manual

Figure 16: 1-Port Clear Channel DS3/E3 GPIM Front Panel
NOTE: Only the SRX650 Services Gateway supports hot-swappable functionality for GPIMs.
The SRX550 Services Gateway does not support hot-swappable functionality for GPIMs.

1-Port Clear Channel DS3/E3 GPIM Components

The 1-Port Clear Channel DS3/E3 GPIM contains the components listed in
Table 40: 1-Port Clear Channel DS3/E3 GPIM Components
Component
ONLINE/OFFLINE button
Only the SRX650 Services Gateway
supports hot-swappable functionality
for GPIMs. The SRX550 Services
Gateway does not support
hot-swappable functionality for
GPIMs.
TX and RX coaxial connectors
Captive screws
Location
Right side of the GPIM
Middle/right of the GPIM
One on each side of the GPIM
Table 40 on page 78.
Description
Use the ONLINE/OFFLINE button
to gracefully shut down the GPIM.
Press down and hold the button for
4 to 5 seconds; then release. The
GPIM gracefully shuts down and
turns off the power supply units
(PSUs).
To power up the GPIM (if the
Services and Routing Engine [SRE] is
off), press and hold the
ONLINE/OFFLINE button for 4 to 5
seconds.
Dual 75-ohm BNC coaxial socket
connectors: TX (transmit) and RX
(receive).
Use the captive screws to hold the
GPIM in place.
78