Table of Contents
Advertisement
RELATED DOCUMENTATION
8-Port Serial GPIM Hardware Specifications | 102
8-Port Serial GPIM Components | 100
8-Port Serial GPIM Key Features | 101
8-Port Serial GPIM LEDs | 103
8-Port Serial GPIM Interface Cables | 157
8-Port Serial GPIM Interface Specifications | 27
8-Port Serial GPIM Basic Configuration | 225
8-Port Serial GPIM Components
Table 51 on page 100
lists the components of the 8-Port Serial Gigabit-Backplane Physical Interface Module
(GPIM).
Table 51: 8-Port Serial GPIM Components
Component
ONLINE/OFFLINE button
Only the SRX650 Services Gateway
supports hot-swappable functionality
for GPIMs. The SRX550 Services
Gateway does not support
hot-swappable functionality for
GPIMs.
Connector
Captive screws
Location
Right side of the GPIM
Middle or right of the GPIM
One on each side of the GPIM
Description
Use the ONLINE/OFFLINE button
to gracefully shut down the GPIM.
Press down and hold the button for
4 to 5 seconds and then release. The
GPIM gracefully shuts down and
turns off the power supply units
(PSUs).
To power up the GPIM (if the
Services and Routing Engine is off),
press and hold the
ONLINE/OFFLINE button for 4 to 5
seconds.
Two dual stacked 136-pin VHDCI
connectors. Custom cables are used
to connect from the VHDCI
connectors to the data terminal
equipment (DTE) or the data
circuit-terminating equipment (DCE)
Use the captive screws to hold the
GPIM in place.
100
Advertisement
Table of Contents
