1-Port Serial Mini-Physical Interface Module; 1-Port Serial Mini-Physical Interface Module Overview - Juniper SRX Series Manual

CHAPTER 8

1-Port Serial Mini-Physical Interface Module

IN THIS CHAPTER

1-Port Serial Mini-Physical Interface Module Overview | 62

1-Port Serial Mini-Physical Interface Module Key Features | 63
1-Port Serial Mini-Physical Interface Module Hardware Specifications | 63
1-Port Serial Mini-Physical Interface Module LEDs | 64
1-Port Serial Mini-Physical Interface Module Supported Standards | 65
1-Port Serial Mini-Physical Interface Module Overview
Serial WAN links are bidirectional links and require very few control signals. In a basic serial setup, the
data circuit-terminating equipment (DCE) is responsible for establishing, maintaining, and terminating a
connection. A modem is a typical DCE device. A serial cable connects the DCE to a telephony network
where, ultimately, a link is established with data terminal equipment (DTE). DTE is typically where a link
terminates.
Figure 13 on page 62 shows the front panel of the 1-Port Serial Mini-Physical Interface Module (Mini-PIM).
Figure 13: 1-Port Serial Mini-PIM Front Panel
RELATED DOCUMENTATION
1-Port Serial Mini-Physical Interface Module Hardware Specifications | 63
1-Port Serial Mini-Physical Interface Module Supported Standards | 65
1-Port Serial Mini-Physical Interface Module Key Features | 63
62