CHAPTER 14
8-Port Serial GPIM
IN THIS CHAPTER
8-Port Serial GPIM Overview | 99
8-Port Serial GPIM Components | 100
8-Port Serial GPIM Key Features | 101
8-Port Serial GPIM Hardware Specifications | 102
8-Port Serial GPIM LEDs | 103
8-Port Serial GPIM Overview
The 8-Port Serial Gigabit-Backplane Physical Interface Module (GPIM) is a hot-swappable network interface
card (NIC) that installs in the front slots of the SRX650 and SRX550 Services Gateways to provide physical
connections to a WAN. It can be plugged in all the slots of SRX650 and SRX550 Services Gateways. After
you install the GPIM in the services gateway, you configure a network interface on the GPIM. It provides
higher port density and flexible support for universal serial ports including a wide array of interface options
such as synchronous support.
NOTE:
Only the SRX650 Services Gateway supports hot-swappable functionality for GPIMs.
The SRX550 Services Gateway does not support hot-swappable functionality for GPIMs.
All the ports of the 8-Port Serial GPIM are connected to two dual stacked 136-pin VHDCI connectors.
Custom cables are used to connect from the VHDCI connectors to data terminal equipment (DTE) or data
circuit-terminating equipment (DCE). Different cables are required to support different protocols. The
protocols that a cable supports are identified using the cable ID. The cables are labeled with a letter (refers
to the cable type) and four digits (unique serial numbers for the cables).
Figure 22: 8-Port Serial GPIM Front Panel
P5
P7
99