Table of Contents
Advertisement
CHAPTER 15
16-Port Gigabit Ethernet XPIM
IN THIS CHAPTER
16-Port Gigabit Ethernet XPIM Overview | 104
16-Port Gigabit Ethernet XPIM Components | 105
16-Port Gigabit Ethernet XPIM Key Features | 107
16-Port Gigabit Ethernet XPIM Hardware Specifications | 107
16-Port Gigabit Ethernet XPIM LEDs | 108
16-Port Gigabit Ethernet XPIM Overview
The 16-Port Gigabit Ethernet XPIM is a double-high, single-wide LAN switch Gigabit-Backplane Physical
Interface Module (GPIM) that uses two standard slots vertically. It is available with or without Power over
Ethernet (PoE) support. The PoE GPIMs provide ports that supply electric power over the same ports that
are used to connect network devices. For more information about PoE, see
on SRX Series Services Gateway Interfaces" on page
The 16-Port Gigabit Ethernet XPIM must be installed in one of the following 20-Gigabit slots on the services
gateway:
SRX550—Slot 3 or 6
NOTE:
The 16-Port Gigabit Ethernet XPIM is supported on both slot 3 and slot 6 of the SRX550
Services Gateway. However, the performance (bandwidth) in slot 3 will be limited as it has a
10G back link.
SRX650—Slot 2 or 6
NOTE:
Only the SRX650 Services Gateway supports hot-swappable functionality for GPIMs.
The SRX550 Services Gateway does not support hot-swappable functionality for GPIMs.
"Power over Ethernet Support
15.
104
Advertisement
Table of Contents
