8-Port Gigabit Ethernet Sfp Xpim; 8-Port Gigabit Ethernet Sfp Xpim Overview - Juniper SRX Series Manual

CHAPTER 13

8-Port Gigabit Ethernet SFP XPIM

IN THIS CHAPTER

8-Port Gigabit Ethernet SFP XPIM Overview | 92

8-Port Gigabit Ethernet SFP XPIM Components | 93
8-Port Gigabit Ethernet SFP XPIM Key Features | 94
8-Port Gigabit Ethernet SFP XPIM Hardware Specifications | 95
8-Port Gigabit Ethernet SFP XPIM LEDs | 96
8-Port Gigabit Ethernet SFP XPIM Supported Modules | 97
8-Port Gigabit Ethernet SFP XPIM Overview
The ports of the 8-Port Gigabit Ethernet small form-factor pluggable Gigabit-Backplane Physical Interface
Module (SFP XPIM) can be used for connecting to Ethernet WAN service as well as for local server
connectivity at Gigabit Ethernet speeds. The XPIM enables Layer 2 line-rate Gigabit switching and
system-processor dependent Layer 3 service with connection of up to eight SFP Gigabit Ethernet ports.
The 8-Port Gigabit Ethernet SFP XPIM complements the on-board 10/100/1000 Mbps Ethernet interfaces
with extended WAN connectivity. It supports a variety of transceivers. This XPIM can be used in copper
and optical environments to provide maximum flexibility when upgrading from an existing infrastructure
to Metro Ethernet.
The 8-Port Gigabit Ethernet XPIM can be installed in any GPIM slot on the SRX550 and SRX650 Services
Gateways.
The earliest supported release on the 8-Port Gigabit Ethernet XPIM is Junos OS Release 12.1X44-D10.
Figure 21 on page 92 shows the front panel of the 8-Port Gigabit Ethernet SFP XPIM.
Figure 21: 8-Port Gigabit Ethernet SFP XPIM Front Panel
92