CHAPTER 16
24-Port Gigabit Ethernet XPIM
IN THIS CHAPTER
24-Port Gigabit Ethernet XPIM Overview | 111
24-Port Gigabit Ethernet XPIM Components | 112
24-Port Gigabit Ethernet XPIM Key Features | 115
24-Port Gigabit Ethernet XPIM Hardware Specifications | 116
24-Port Gigabit Ethernet XPIM LEDs | 117
24-Port Gigabit Ethernet XPIM Overview
The 24-Port Gigabit Ethernet XPIM is a double-high, double-wide LAN switch Gigabit-Backplane Physical
Interface Module (GPIM) that uses two standard slots vertically and two standard slots horizontally. It is
available with or without Power over Ethernet (PoE) support. The PoE GPIMs provide ports that supply
electric power over the same ports that are used to connect network devices. For more information about
PoE, see
"Power over Ethernet Support on SRX Series Services Gateway Interfaces" on page
The 24-Port XPIM must be installed in specific GPIM slot groupings as shown in
Table 57: Slot Groups for the 24-Port Gigabit Ethernet XPIM
Device
Slot Groups for the 24-Port Gigabit Ethernet XPIM
SRX550 Services
Top four standard slots (slots 5, 6, 7, and 8)
Gateway
SRX650 Services
Bottom four standard slots (slots 1, 2, 3, and 4) and top four standard slots (slots 5, 6, 7, and
Gateway
8)
The center GPIM slot bracket must be removed before installing a double-high, double-wide GPIM. See
"Installing a Double-High, Double-Wide Gigabit-Backplane Physical Interface Module on the SRX Series
Services Gateway" on page 256
The earliest supported release on the 24-Port Gigabit Ethernet XPIM is Junos OS Release 9.5.
for details.
15.
Table 57 on page
111.
111