1-Port Adsl2+ Mini-Physical Interface Module Leds; 1-Port Adsl2+ Mini-Physical Interface Module Supported Standards - Juniper SRX Series Manual

1-Port ADSL2+ Mini-Physical Interface Module Supported Loopback Diagnostics | 49
1-Port ADSL2+ Mini-Physical Interface Module Basic Configuration | 201

1-Port ADSL2+ Mini-Physical Interface Module LEDs

The 1-Port ADSL2+ Mini-Physical Interface Module (Mini-PIM) has two LEDs.
the LED states.
Table 28: 1-Port ADSL2+ Mini-PIM LED States
LED Color
SYNC Green
TX/RX Green
RELATED DOCUMENTATION
1-Port ADSL2+ Mini-Physical Interface Module Overview | 45
1-Port ADSL2+ Mini-Physical Interface Module Hardware Specifications | 47
1-Port ADSL2+ Mini-Physical Interface Module Network Interface Specifications | 21

1-Port ADSL2+ Mini-Physical Interface Module Supported Standards | 48

1-Port ADSL2+ Mini-Physical Interface Module Key Features | 46
1-Port ADSL2+ Mini-Physical Interface Module Supported Loopback Diagnostics | 49
1-Port ADSL2+ Mini-Physical Interface Module Basic Configuration | 201
1-Port ADSL2+ Mini-Physical Interface Module Supported Standards
The 1-Port ADSL2+ Mini-Physical Interface Module (Mini-PIM) supports the following standards:
State Description
On Indicates that the ADSL interface is trained
Blinking Indicates training is in progress
Off Indicates that the interface is idle
Blinking Indicates that traffic is passing through
Off Indicates that no traffic is passing through
Table 28 on page 48 describes
48