Options Dialog Box; Dp Slave Properties Dialog Box - Siemens ET 200S Manual

Configuration Options
Constant bus
cycle time
Activate constant bus cycle/recalculate constant bus cycle time
Number of PGs/OPs/TDs on PROFIBUS
Configured:
Constant DP Cycle:
(minimum
Slave synchronization
Times Ti and To same for all Slaves
(if not: set in Properties - Slaves)
Time Ti (read in process values):
(minimum
Time To (output process values):
(minimum
Figure 3-7
3. Carry out settings on the DP slave:
"Object Properties" of the DP slave > "Clocking" tab
– Enable "Synchronize DP slave with DP cycle".
– Enter the times Ti and To (if "Times Ti and To same for all slaves" has not
been set on the DP master system). Recommended: Accept the default
settings for Ti and To.
– Select the electronic modules to be synchronized, and assign them on the
"Addresses" tab to the partial process image defined in the CPU.
DP Slave Properties
General
Synchronize DP slave with DP cycle
Time Ti (read in process values):
Time To (output process values):
Figure 3-8
3-28
Network stations
Cables
Total:
0
8.000
5.875 ms)
4.3750 ms)
0.4375 ms)

Options Dialog Box

Slave parameters
Clocking

DP Slave Properties Dialog Box

0
Time base:
ms 0.125 ms
Time Base:
4.4375 ms 0.0625
Time Base:
0.5000 ms 0.0625
Time base:
4.4375 ms
Time base:
0.5000 ms
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Details ...
ms
ms
ms
ms