Siemens ET 200S Manual page 153

6.6.2 Structure of the Slave Diagnosis
Structure of the Slave Diagnosis
IM151-1 BASIC
Byte 0
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
*
:
Byte 8
Byte 9
*
:
Byte 15
Byte 16
*
Byte 17
Byte 18
:
Byte 42
* These diagnoses can be disabled or enabled by parameter. If you disable the diagnoses, they
are removed from the diagnostic frame.
** Only in the case of the IM151-1 HIGH FEATURE in DPV1 operation. If you disable the
interrupts, the additional area becomes available for channel-specific diagnoses.
Figure 6-20 Structure of the Slave Diagnosis
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
IM151-1 STANDARD
IM151-1 FO STANDARD
IM151-1 HIGH FEATURE
Byte 0
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
:
Byte 14
Byte 15
:
Byte 34
Byte 35
Byte 36
Byte 37
:
Byte 63
:
Up to
byte 127
Commissioning and Diagnostics
Station statuses 1 to 3
Master PROFIBUS Address
High byte
Manufacturer ID
Low byte
*
Module
diagnosis
*
Module
Status
Channel-specific diagnosis
*
(3 bytes per channel)
The channel-specific
diagnosis varies
from 0 to 45 bytes. This
depends on the number of
channel-specific diagnoses.
Interrupts
* **
Up to
(only 1 interrupt possible for each slave
48 bytes
diagnostic frame)
6-29