Siemens ET 200S Manual page 3

Introduction
Purpose of the Manual
The information in this manual enables you to run the ET 200S distributed I/O
system on PROFIBUS-DP as a DP slave.
Required Level of Knowledge
Knowledge of the field of automation engineering is required to understand the
manual.
Scope of the Manual
This manual is valid for the components of the ET 200S distributed I/O system
specified in Appendix A.
This manual contains a description of the components that were valid at the time
the manual was published. We reserve the right to enclose a Product Information
bulletin containing up-to-date information about new components and new versions
of components.
Changes Since the Previous Version
The following changes/additions have been made since the previous version of the
manual:
S Clocking
S IM151-1 BASIC interface module
S Fast Connect terminal module
S 4DI 24–48 VUC High Feature electronic module
S 4DI 24 VDC/SRC Standard electronic module
S 2RO NO/NC 24–48 VDC/0.5 A, 24–230 VAC/5 A electronic module
S 2AI RTD High Feature electronic module
Note: The number in the footer indicates the previous version of this "ET 200S"
manual: EWA 4NEB 780 6024-0x-06.
The current number is: EWA 4NEB 780 6024-0x-07.
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
iii