Siemens ET 200S Manual page 417

Table 12-74 Parameters for Analog Input Modules RTD, TC
2AI RTD 2AI TC
Standard Standard
––– Type/range
of measure-
ment
1
Only with thermocouples. A parameter assignment error occurs when the wire break diagnosis is enabled
in the voltage measuring range. The module does not start up.
2
The wire break is only detected with constant-current lines.
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
2AI TC High
Feature
S
––– Deactivated
S
Voltage
S
TC-EL type T (Cu-CuNi)
S
TC-EL type K (NiCr-Ni)
S
TC-EL type B (PtRh-PtRh)
S
TC-EL type N (NiCrSi-NiSi)
S
TC-EL type E (NiCr-CuNi)
S
TC-EL type R (PtRh-Pt)
S
TC-EL type S (PtRh-Pt)
S
TC-EL type J (Fe-Cu-Ni)
S
TC-EL type L (Fe-Cu-Ni)
S
Type/range of Deactivated
S
measurement
Voltage
S
TC-EL type T (Cu-CuNi)
S
TC-EL type K (NiCr-Ni)
S
TC-EL type B (PtRh-PtRh)
S
TC-EL type C (WRe-WRe)
S
TC-EL type N (NiCrSi-NiSi)
S
TC-EL type E (NiCr-CuNi)
S
TC-EL type R (PtRh-Pt)
S
TC-EL type S (PtRh-Pt)
S
TC-EL type J (Fe-Cu-Ni)
S
TC-EL type L (Fe-Cu-Ni)
Analog Electronic Modules
Value Range

80 mV

80 mV
Default Applica-
bility
TC-EL Channel
type K
(NiCr-Ni)
TC-EL Channel
type K
(NiCr-Ni)
12-61