Siemens ET 200S Manual page 126

Commissioning and Diagnostics
6.1 Configuring the ET 200S
Introduction
This chapter describes how to configure and assign parameters to the ET 200S.
S Configuration: The systematic arrangement of the different ET 200S modules
(setup)
S Parameter assignment: Setting the ET 200S parameters using the configuration
software
Note
The ET 200S is included in the hardware catalog of HWCONFIG:
S
IM151-1 BASIC: as of STEP7 V5.2
S
IM151-1 STANDARD: as of STEP7 V5.0 with ServicePack 3
S
IM151-1 FO STANDARD: as of STEP7 V5.1 with ServicePack 1
S
IM151-1 HIGH FEATURE: as of STEP7 V5.1 with ServicePack 3
You will not need a device database file (*.GSD file). Advantages:
S
Simplified grouping of the modules (by means of the "Pack Addresses" button
in HWCONFIG)
S
Plausibility checking of the parameters
The STEP 7 online help provides more detailed information on how to proceed.
STEP 7
S STEP7 does not support the reading back of the configuration (PLC
S It is not possible to read out the ET 200S diagnosis via the CPU 315-2 DP (with
the "Diagnosing Hardware" function in STEP7) until order no. 6ES7 315-2AF02.
6-2
Upload).
"
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07