Siemens ET 200S Manual page 217

Table 8-3
IM151-1 HIGH
FEATURE
Insert/remove-module
1
interrupt
Identifier-related
diagnostics
Module status
Channel-specific
diagnosis
Analog-value format
Interference
frequency
suppression
Reference junction
slot
Reference junction
input
1
In the device database file, the default setting of the parameter is "Enable".
2
Only parameterizable in DPV1 operation of the IM151-1 HIGH FEATURE.
Table 8-4
IM151-1 HIGH
FEATURE
Synchronize DP
slave with DP cycle
Time Ti (read in
process values)
Time To (read out
process values)
1
Only parameterizable as of STEP7 V5.1 with ServicePack 3
DPV1 Operation (only with IM151-1 HIGH FEATURE)
This parameter allows you to enable or disable DPV1 operation of the ET 200S. If
DPV1 operation is enabled, C1 data records and interrupts are supported
(parameterizable).
Prerequisite:
S The DP master also support DPV1.
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Parameters for the IM151-1 HIGH FEATURE Interface Module (Parameter
Assignment Tab)
Value Range
Disable/enable
Disable/enable
Disable/enable
Disable/enable
SIMATIC S7/
SIMATIC S5
50 Hz/ 60 Hz
None/2 to 63
RTD on channel 0/
RTD on channel 1
Parameters for the IM151-1 HIGH FEATURE Interface Module (Clocking Tab)
Value Range
Disable/enable
1
(Values are preset by
1
STEP 7)
(Values are preset by
1
STEP 7)
Interface Modules
Default
Disable ET 200S
Enable ET 200S
Enable ET 200S
Enable ET 200S
S7 ET 200S
50 Hz ET 200S
None ET 200S
0 ET 200S
Default
Disable ET 200S
(Value is preset by ET 200S
STEP 7)
(Value is preset by ET 200S
STEP 7)
Applicability
Applicability
8-3