1Count 24V/100Khz; 1Count 5V/500Khz - Siemens ET 200S Manual

Commissioning and Diagnostics
Table 6-16 1SSI
Error Type
16 10000: Parameter
D
assignment error
26 11010: External fault
D

1Count 24V/100kHz

Table 6-17 1Count 24V/100kHz
Error Type
1 00001: Short circuit
D
5 00101: Temperature rise
D
6 00110: Open circuit
D
9 01001: Error
D
16 10000: Parameter
D
assignment error

1Count 5V/500kHz

Table 6-18 1Count 5V/500kHz
Error Type
1 00001: Short circuit
D
5 00101: Temperature rise
D
6 00110: Open circuit
D
9 01001: Error
D
6-44
Meaning
Parameters have not been
assigned to the module.
Start/stop bit error (absolute
position encoder error): Wire
break in the sensor cable or
sensor cable is not connected.
Sensor type, transmission rate,
and monoflop time do not
correspond to the sensor
connected; programmable
sensors do not correspond to the
settings on the 1SSI EM. Sensor
is defective or there are faults.
Meaning
Short circuit of the sensor
supply or the actuator.
Digital output is overloaded.
Line to the actuator interrupted.
Internal module error occurred.
Load voltage from the power
module is too low.
Parameters have not been
assigned to the module.
Meaning
Short circuit of the sensor
supply or the actuator.
Digital output is overloaded.
Line to the actuator interrupted.
Internal module error occurred.
What to Do
Adjust the parameter
assignment.
Replace the sensor; correct the
process wiring.
Correct the parameter
assignment.
What to Do
Check the wiring to the sensor.
Correct the process wiring.
Correct the process wiring.
Correct the process wiring.
Replace the module.
Correct the process wiring.
Check the load voltage.
Adjust the parameter
assignment.
What to Do
Check the wiring to the sensor.
Correct the process wiring.
Correct the process wiring.
Correct the process wiring.
Replace the module.
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07