Siemens ET 200S Manual page 280

Digital Electronic Modules
Parameters for Digital Output Modules
Table 11-2 Parameters for Digital Output Modules
2DO 24 2DO
VDC/ 24–230 VAC/
0.5 A High 1 A
Feature
2DO 24 2RO NO
VDC/ 24–120 VDC/
2 A High 5 A
Feature 24–230 VAC/
5 A
Reaction to CPU/Master STOP
1
Substitute value
---
Diagnos-
tics: Wire
break
Diagnostics:
Short-circuit
to M
1
If the IM151-1/ IM151-1 FO Standard is deenergized, the digital output modules do not produce any substitute
values. The value that is output = 0.
Hardware interrupt
This parameter enables the hardware interrupts for the module.
Input Delay
You can use this parameter to suppress signal interference. Changes to the signal
are detected once the set time has elapsed.
Trigger for hardware interrupt, rising edge
This parameter allows you to enable a hardware interrupt at a rising edge (of a
signal status change) for each channel.
11-4
2DO/ 4DO
2RO NO/NC 24 VDC/
24–48 VDC/ 0.5 A ST
5 A
24–230 VAC/
2DO/ 4DO
5 A
24 VDC/
2 A ST
–––
–––
Diagnostic Inter- –––
rupt
–––
–––
Value Range Default
S
Switch Substitute
substitute a value
value
S
Keep last
value
S
"0" "0"
S
"1"
S
Disable Disable
S
Enable
S
Disable Disable
S
Enable
S
Disable Disable
S
Enable
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Applicabil-
ity
Module
Channel
Module
Channel
Channel