Settings on the Fibre Channel Card (8Gbps FC Card)
2.2.4 Enabling BIOS
Enable the HBA BIOS so that the HBA can recognize the LUNs of the SAN storage unit and to enable the system to be
started from one of them.
1.
Select [Enable/Disable Boot form SAN], and then press the [Enter] key.
FIGURE 2.57 Enable/Disable Boot form SAN setup screen(1)
Set [Boot BIOS] is "Enabled," and then press the [Enter] key.
2.
FIGURE 2.58 Enable/Disable Boot form SAN setup screen(2)
Note
Confirm that [Boot BIOS] is "Enabled."
C122-E206-04EN
47