Fujitsu PRIMEQUEST 2000 Series Manual page 11

Configuring the SAN Boot Environment
19. Select [Commit Changes and Exit] in the [Delete Boot Option] screen.
20. Select [Reset System] in the [Boot Maintenance Manager] screen, and then reboot the Partition.
Please initialize the setting of the FC card side when there is the following configuration changes after introducing the system.
Setting on an FC card is redone. If resetting is completed, please reboot system.
When a dump device of sadump is registered with an FC card..
-
When SAN storage and setting change in the FC switch were performed. (Change in the LUN mapping. Host
-
affinity and each port zoning change etc)
When the OS which starts by configuration change is changed.
-
When you register the device to the FC card to add the LUN device
-
Please refer to "2.1.5/3.1.5 the initialization of the FC card setting" for the initialization of the FC card.
Please refer to the following for the FC card resetting.
CHAPTER 2 Settings on the Fibre Channel Card (8Gbps FC Card)
CHAPTER 3 Settings on the Fibre Channel Card (16Gbps FC Card)
C122-E206-04EN
11