Fujitsu PRIMEQUEST 2000 Series Manual page 35

Settings on the Fibre Channel Card (8Gbps FC Card)
Important) Do not select [Back to Display Adapters and RECONNECT DEVICES] to return to the higher menu,
If select, your system will hung up. If your system hung up and is not operated for three minutes and over,
reset the system and restart setting procedures.
FIGURE 2.39 Boot device setting (15)
15. For a multipath configuration, make the settings described in the sections from 2.1.3 Starting the HBA setup utility to
2.1.7 Speed and Topology settings for all the HBAs connected to the SAN storage unit LUN from which the system is
started. Also, after installing the operating system and multipath driver, perform the operation described in 3.1.8 Boot
device setting for all the HBAs used to start the system.
After finishing all the settings, select [Exit Emulex HBA Configuration Utility], and then press the [Enter] key to return to
the Device Manager menu.
Note
If following message appears following the operations below, press the [N] key or [ESC] key.
You need not perform another operation here because the [Commit Changes] or [Discard Changes] operation from the
menu completes the task of changing or discarding settings.
Select the relevant item from the [Delete Boot Device] or [Change Boot Device Order] menu.
↓
Select [Commit Changes] or [Discard Changes].
↓
Go back to the [Delete Boot Device] or [Change Boot Device Order] menu.
C122-E206-04EN
35