Fujitsu PRIMEQUEST 2000 Series Manual page 88

Configuring the san boot environment

Hide thumbs Also See for PRIMEQUEST 2000 Series:

Table of Contents

Settings on the Fibre Channel Card (16Gbps FC Card)

3.2.3 Link Speed and Topology Settings

The following describes how to make the Speed and Topology settings.

■Topology Setting

Select [Configure Advance Adapter Parameters] form the Main menu, and then press the [Enter] key.

Select [Topology Selection], and then press the [Enter] key.

When you connect 16Gbps FC Card to the storage supporting 16 Gbps, you have to connect via FC switch. Note that

conventional FCAL connection is not supported in above case. Confirm SAN connection configuration and select the

appropriate setting, and then press the [Enter] key. Change the setting from [Auto Topology: Loop first] (Default) by referring

to the connection setting in the following screen.

Fabric Connection: Fabric Point to Point

C122-E206-04EN

FIGURE 3.42 Topology Selection Setting (1)

FIGURE 3.43 Topology Selection Setting (2)

Table of Contents