Fujitsu PRIMEQUEST 2000 Series Manual page 60

Settings on the Fibre Channel Card (16Gbps FC Card)
3. The [Device Manager] screen appears.
Note
The following points when using UEFI driver version 6.11a5 or later to set a SAN boot configuration on the 16Gbps FC Card.
Refer to [Display Adapter Info] in the [Port 001:Emulex LPe16002B-M6-F 16Gb 2-port PCIe Fibre Chann] screen to check
the UEFI driver version.

Before deleting a registered boot entry with the Delete Boot Device process, be sure to change the BIOS enable
setting (Set Boot from SAN) to Disable.

Executing the Delete Boot Device process with Enable as the BIOS enable setting (Set Boot from SAN) may render
Emulex Configuration Utility inoperable on rare occasions. In such cases, select [Reset] from the [Power Control]
window of the MMB Web-UI to restart the system. Then, make the settings on the 16Gbps FC Card again.
C122-E206-04EN
** The order of device may vary each time you enter into Device Mangager menu.
FIGURE 3.2 [Device List]
60