Fujitsu PRIMEQUEST 2000 Series Manual page 67

Settings on the Fibre Channel Card (16Gbps FC Card)
2. Confirm that [Set Boot from SAN < Enable >] is displayed.
3.1.7 Link Speed and Topology settings
The following describes how to make the Link Speed and Topology settings.
Note
When you connect 16Gbps FC Card to the storage supporting 16Gbps, you have to connect via FC switch.
Note that conventional FCAL connection is not supported in above case. If you will use 16 Gbps FC card made the Link
Speed slowed down into 4/8Gbps, FCAL connection can be available.
Static Topology setting
On the [Emulex Adapter Configuration Main Menu] screen, make the following setting that corresponds to the connection
pattern (Fabric connection/FCAL connection).
C122-E206-04EN
FIGURE 3.10 [Set Boot from SAN] (Enabling boot (2))
67