Fujitsu PRIMEQUEST 2000 Series Manual page 110

Consideration of Linux Installation
3. The following popup appears. Use the [+] key and [-] key to move FC to the top. Press the [Enter] key.
4. Press the [Enter] key to return [Set Legacy HardDisk Driver Order] screen. Select [Commit Change and Exit], and
then press the [Enter] key. Press the [ESC] key to return [Boot Manager] screen
Configuring an SAS disk as a non-boot device
1. Open the [Set Legacy HardDisk Drive Order] menu.
2. Select the HardDisk Drive #N that you want to disable. Press the [Space] key
3. Confirm that [//] appears on the front disabled SAS disk.
Set the HardDisk Drive #N to disable.
If there are multiple SAS disks, repeat the above setting for every SAS disk.
4. Press the [Enter] key to return from the popup screen.
5. Execute [Commit Changes and Exit] to exit.
6. Open [Set Legacy HarDisk Drive Order] again for confirmation.
7. Confirm the following:
All HardDisk Drive set to SAS disk are disabled.
C122-E206-04EN
FIGURE 5.8 [Set Legacy HardDisk Driver Order] screen (for setting the order of devices)
110