Fujitsu PRIMEQUEST 2000 Series Manual page 85
Configuring the san boot environment
Hide thumbs
Also See for PRIMEQUEST 2000 Series:
- Tool reference (734 pages) ,
- Administration manual (467 pages) ,
- Message reference (232 pages)
Table of Contents
Advertisement
Settings on the Fibre Channel Card (16Gbps FC Card)
3.2
Procedure for Setting Legacy BIOS Driver Version 6.02x6 or Later on the 16Gbps
FC Card
This section describes the procedure for setting Legacy BIOS driver version 6.02x6 or later.
Confirm the setting to boot by using Legacy BIOS mode by referring to the procedures in 2.2.1 and 2.2.2.
3.2.1 Starting the HBA Setup Utility
Press [Alt]+ [E] or [Ctrl]+ [E] key during the following massage appears.
1.
Start LightPluse BIOS Utility.
2.
FC ports of Fibre Channel Card appear in HBA Listing screen. Select a FC port to set up and press [Enter] key.
C122-E206-04EN
FIGURE 3.37 Starting Legacy BIOS HBA Setup
FIGURE 3.38 Emulex LightPlus BIOS Utility Screen (1)
85
Advertisement
Table of Contents
