Fujitsu PRIMEQUEST 2000 Series Manual page 97

Settings on the Fibre Channel Card (16Gbps FC Card)
11. Press the [ESC] key, then returns to the Main menu.
Remarks
If the expected Fibre Device is not displayed, there is a possibility that the setting of the SAN storage or the setting or
physical connection of the FC switch is incorrect.
Confirm these settings once again.
12. Press the [ESC] key, then message to save the setting is displayed. then, returns to the [Device Manager].
13. For a multipath configuration, make the settings described in the sections from 3.2.1 Starting the HBA setup utility to 3.2.3
Speed and Topology settings for all the HBAs connected to the SAN storage unit LUN from which the system is started.
Also, after installing the operating system and multipath driver, perform the operation described in 3.2.4 Boot device setting
for all the HBAs used to start the system.
After finishing all the settings, select [Exit Emulex HBA Configuration Utility], and then press the [Enter] key to return to the
Device Manager menu.
C122-E206-04EN
FIGURE 3.60 Boot device setting (11)
97