Fujitsu PRIMEQUEST 2000 Series Manual page 83

Settings on the Fibre Channel Card (16Gbps FC Card)
3.1.10 Recording the WWN of the FC port
According to the design drawing of the SAN boot environment, write down the WWN (World Wide Name), specific
address information assigned to the FC port of the 16Gbps FC Card of each server.
FIGURE 3.36 [Adapter Selection] menu
Remarks
If you are updating 16Gbps FC Card firmware (e.g., Boot BIOS), check the WWN after the firmware update.
To clearly identify the mounting location of the 16Gbps FC Card, record the host name (the one that identifies the
PRIMEQUEST 2000 series server), mounted card, mounting slot location, BUS number, and DEV number. For the BUS
number and slot number, check the BUS number and slot number of the target HBA from the [IOU] menu and [PCI_Box]
menu of the MMB Web-UI.
The BUS number appears as the middle number of the three numbers delimited by slash in the [Seg/Bus/Dev] item.
The following example shows how the WWNs are recorded.
83
C122-E206-04EN