Fujitsu PRIMEQUEST 2000 Series Manual page 72

Settings on the Fibre Channel Card (16Gbps FC Card)
5. After the completion of the Commit Changes process, you are returned to the [Port 001:Emulex LPe16002B-M6-F
16Gb 2-port PCIe Fibre Chann] screen.
FIGURE 3.19 Topology / Link Speed change confirmation (2)
Remarks
After changing the [Topology Selection] or [Force Link Speed] settings and then selecting [Discard Changes], if you are
returned to the screen for changing settings, the changes to the 16Gbps FC Card settings have been discarded. However,
you may still see the changed settings displayed by the utility.
If so, select the 16Gbps FC Card again from the menu as described in 3.1.3 Starting the HBA Setup Utility and Selecting
an HBA, before proceeding with the work.
Changing the setting of the opposing device
The setting of the opposing Fibre Channel switch and SAN storage unit disk array must also be made static so that it
corresponds to the static setting of the 16Gbps FC Card.
For details on the settings required on the ETERNUS when connecting to it, see the ETERNUS manuals at the following
website:
http://www.fujitsu.com/global/support/products/computing/storage/disk/manuals/
72
C122-E206-04EN