Fujitsu PRIMEQUEST 2000 Series Manual page 16

Settings on the Fibre Channel Card (8Gbps FC Card)
5. The controller Information is displayed.
Select [Display Adapter Info], and then press the [Enter] key. Check the Firmware and EFI BIOS.
Note
the following points when using UEFI driver version 4.13a6 or later to set a SAN boot configuration on
the 8Gbps FC Card. (In the above example, Emulex Configuration Utility Ver. is 4.13a6.)

Before deleting a registered boot entry with the Delete Boot Device process, be sure to change the BIOS enable
setting (Set Boot from SAN) to Disable.

Executing the Delete Boot Device process with Enable as the BIOS enable setting (Set Boot from SAN) may render
Emulex Configuration Utility inoperable on rare occasions. In such cases, select [Reset] from the [Power Control]
window of the MMB Web-UI to restart the system. Then, make the settings on the 8Gbps FC Card again.
C122-E206-04EN
FIGURE 2.4 Controller Information
16