Fujitsu PRIMEQUEST 2000 Series Manual page 111

Consideration of Linux Installation
FIGURE 5.9 [Set Legacy HardDisk Driver Order] screen (Confirm SAS boot)
Starting the partition and confirming the built-in disk
After completing the UEFI setting, start the partition.
After starting the partition, execute the following command to confirm the difference between the current state and the
state in which the built-in disk had not been mounted yet.
# ls –l /dev/disk/by-id
The disk that was confirmed not to exist before the addition of the built-in disk is the added built-in disk.
Creating partitions of the built-in disk
Create disk partitions in the built-in disk, and create a swap file system and other necessary files.
Remarks
Fujitsu recommends you to place the swap partition in the built-in hard disk. For details, contact
your sales representative or a field engineer.
C122-E206-04EN
111